CONSTRUCTION OF SHEEL AND TUBE HEAT EXCHANGER

ABSTRACT

The aim of this project was to construct shell and tube heat exchanger with fixed boundless. A heat exchanger that would cool 5 x 5 x 10 – 3 kg/s of steam at a calculated heat load of 152 – 395/S was fabricated. The steam is to reach the heat exchanger from a distillation column at a temperature of 300k. The specification of  the layout as well as the detailed mechanical design were assumed and also calculated.
It is established that a horizontal heat exchanger with cold water at the shall side and the treated steam at the tube side is adequate for this operation, with the aim of cooling the steam from the distillation column.
        The available area obtained from calculation is 1.0m2 and also the overall heat transfer coefficient obtained is 4.10W/M2k. it is also seen that the heat exchanger is satisfactory and consists of five copper tubes of inside diameter 90mm and 5920mm length. The shell inside diameter 810mm and 5.770mm length. The tube and shell heat exchanger has a total length of 5820mm.
The material of construction for the shell side is stainless steel while copper tubes were used for the tubes inside. 
The total cost of the heat exchanger was N12,000.


TABLE OF CONTENTS

Title Page
Approval page
Letter of transmitted
Dedication
Acknowledgements
Abstract 
Table of contents

CHAPTER ONE
1.1Introduction 

CHAPTER TWO 
2.0Literature Review
2.1General Design of Heat Exchanger
2.2Tubular Heat Exchanger
2.3Design Description of the Major Components 
2.4Tubes
2.5Tube Bundles 
2.6Shells 
2.7Baffle 
2.8Tie Road Spacers 
2.9Pass Partition Plates 

CHAPTER THREE 
3.0Fabrication Procedures
3.1Dimensioning and Marking Out 
3.2Cutting 
3.3Folding or Rolling 
3.4Drilling operation 
3.5Assembling Process
3.6Welding Operation
3.7Filling
3.8Dimensions and Parameters Derived
3.9From the Fabrication Units


CHAPTER FOUR
4.0Costing

CHAPTER FIVE
5.0Discussion

CHAPTER SIX
6.0Conclusion
6.1Recommendations

CHAPTER SEVEN
7.0Notation and Nomenclature
References
Appendix
Physical Properties of Water 
Calculation of the Head Load

Subscribe to access this work and thousands more
Overall Rating

0

5 Star
(0)
4 Star
(0)
3 Star
(0)
2 Star
(0)
1 Star
(0)
APA

Research, A. (2018). CONSTRUCTION OF SHEEL AND TUBE HEAT EXCHANGER. Afribary. Retrieved from https://afribary.com/works/construction-of-sheel-and-tube-heat-exchanger

MLA 8th

Research, Afri "CONSTRUCTION OF SHEEL AND TUBE HEAT EXCHANGER" Afribary. Afribary, 03 Feb. 2018, https://afribary.com/works/construction-of-sheel-and-tube-heat-exchanger. Accessed 19 Apr. 2024.

MLA7

Research, Afri . "CONSTRUCTION OF SHEEL AND TUBE HEAT EXCHANGER". Afribary, Afribary, 03 Feb. 2018. Web. 19 Apr. 2024. < https://afribary.com/works/construction-of-sheel-and-tube-heat-exchanger >.

Chicago

Research, Afri . "CONSTRUCTION OF SHEEL AND TUBE HEAT EXCHANGER" Afribary (2018). Accessed April 19, 2024. https://afribary.com/works/construction-of-sheel-and-tube-heat-exchanger