ABSTRACT Condition monitoring of Electrical power equipment has attracted considerable attention for years. The aim of this work is to use Fuzzy logic (FL) Tool Box in building a simulation system that will diagnose all kinds of incipient faults, phase to phase fault and overloading in a transformer and monitor its conditions. Current and rate of change of current with time have been identified as the input variables, duly represented in the programme as “Error” and “Error-Dot”. Thes...
ABSTRACT In the study of the influence of saliency ratio (L /L ) on the performance of a synchronous reluctance generator (SRG), this project investigates two typical generator rotor designs: Generator with cage and without cage otherwise known as cage and cageless rotor respectively. A special attention had been paid to the possible rotor geometries of synchronous reluctance machine, SRM. This ratio can directly influence our insight into the machine’s potential abilities. From the studi...
ABSTRACT Security is one thing human should not joke with, especially in today’s world where crime is at a higher rate. One of the ways of providing security is the introduction of security doors in houses, companies, offices and warehouses. Security doors may prevent or control entry or exit, or they may be merely decorative. Larger doors can be used for a whole building, such as a castle or fortified town, or the actual doors that block entry through the gatehouse. Today many doors are ...
ABSTRACT A digitally controlled light dimmer circuit is based on the principle of power control using thyristor. The switch enables light from an electric bulb to be raised from full brilliance down or up to a high range of luminance. Owning to its construction, adequate conservation of energy is achieved. The circuit is made in various patterns depending on the manufacturer. Some have a rotary knob; some have milled edged control while others have a depressing switch or side...
ABSTRACT This research work designs a wireless power transfer system (WPT) for non smart phones as an alternative to existing wired power supply systems for these devices. Initially, the general concept of known WPT systems and methods are introduced and reviewed. It was noted that most existing WPT models do not consider external interferences in their design even though, it is well known that high frequency circuits may interfere with a WPT system. Additionally till date, existing WPT syste...
ABSTRACT In this current situation, the degree of security is feeble. So there is a lot of robbery, theft going on in and around the world. So, people fear to keep any of their valuables in their homes. Henceforth, many people prefer to keep it in banks. However, in this insecure world even banks are not too safe enough to satisfy people needs. A common man/woman feels his/her valuables are secured if there is efficiency in security. Hence this project can give effective security in minimal c...
TABLE OF CONTENTDECLARATION.................................................................................................................................. iAPPROVAL........................................................................................................................................ iiDEDICATION ...................................................................................................................................iiiACKNOWLEDGMENT...................................
TABLE OF CONTENTSDECLARATION......................................................................................................................... iAPPROVAL............................................................................................................................... iiACKNOWLEDGEMENT.........................................................................................................iiiTABLE OF CONTENTS ......................................................................
TABLE OF CONTENTSDECLARATION ..................................................................................................................iAPPROVAL.........................................................................................................................iiACKNOWLEDGMENT.................................................................................................... iiiTABLE OF CONTENTS..........................................................................................
TABLE OF CONTENTSDeclaration....................................................................................................................................... iApproval .......................................................................................................................................... iDedication....................................................................................................................................... iiAcknowledgement ......................
ABSTRACT As the demand of energy is increasing day by day, so the ultimate solution to deal with these sorts of problems is just to implement the renewable sources of energy Humans are using the renewable energy which are solar, wind etc. but we still could not satisfy our power needs, because of that we have to generate electricity through each and every possible ways. The objective of this work is to produce power through footsteps as a source of renewable energy that we can obtained while ...
TABLE OF CONTENTSDECLARATION........................................................................................................................iAPPROVAL..............................................................................................................................iiMR. ADABARA IBRAHIM.....................................................................................................iiDEDICATION...................................................................................
TABLE OF CONTENTSDECLARATION................................................................................................................................. iAPPROVAL....................................................................................................................................... iiDEDICATION...................................................................................................................................iiiACKNOWLEDGEMENT....................................
ABSTRACT. To achieve most accurate coverage area results during installations of sector antennas, the technical team must create a coverage map for each of the sectors basing on the provided coverage values. The technical team uses these values to make manual position adjustments of sector antennas. Manual antenna adjustments are sometimes risky in a way that unexpected accidents usually occur that even result into death. To overcome such scenarios, an android based sector Antenna positioni...
ABSTRACT This project presents the design and construction of a DC to AC inverter system. It is designed to meet up with the power demand in the offices/homes in the absence of power supply from National Supply Authority. It is designed in such a way that it will take up to 12V DC from battery and inverts it to an output of 220V, 50Hz AC. It makes no noise during operation and not hazardous like carbon monoxide is generated to the surrounding. This is the feature makes it safe to used anywh...