ABSTRACT
In this work, the state of stress between adhesively bonded single lap-joints was
determined. The state of stress between adhesively bonded single lap-joints was determined
by using a linear elastic analysis and experimental testing. In the analysis part of this work,
the shear and normal stresses in an adhesively bonded single lap –joints were predicted by
subjecting the joint to tension; shear force, and bending moments. Differential equations were
used to model the problem and the joint was analyzed using a linear elastic analysis. The
solution of the differential equations was used in predicting the shear and normal (peel) stress
distributions over the single lap-joint. The boundary conditions used limit the analysis to two
adherends having the same thicknesses, lengths, and material properties. In the experimental
testing, twelve single lap-joints were produced. These joints were produced using four
different overlap lengths(12.7mm,14mm,16mm,and 18mm),and then grouped into three with
each group having four single lap-joint of 12.7mm,14mm,16mm,and 18mm overlap lengths.
Each of the three groups were subjected to tension, shear force and bending moments by
using a universal testing machine and dead weights. The shear and normal stress distributions
over the joints were obtained by dividing the applied loads with the area of the overlap region
of the joint. It became evident from this work that increasing the overlap length results in an
increase in joint strength, and a decrease in both the shear and normal stresses due to an
increase in the area of bond. It was also found from this work that maximum stresses occurs
the ends of the overlap region of the joint and are hence the critical regions of the bonded
assembly. It was also found from this work that the failure associated with single lap-joint are
mainly as a result of the failure in the adhesive layer known as adhesive failure. The shear
and normal stresses obtained from these tests were in agreement with those obtained from
analysis in this work. These tests were used to check the analytical results and to establish
confidence in theory. This work could be applied in the determination of the state of stress between adhesively bonded laminated composite door panels.
JEROME, O (2021). Determination Of The State Of Stress Between Adhesively Bonded Single Lap-Joints.. Afribary. Retrieved from https://afribary.com/works/determination-of-the-state-of-stress-between-adhesively-bonded-single-lap-joints
JEROME, OLOTO "Determination Of The State Of Stress Between Adhesively Bonded Single Lap-Joints." Afribary. Afribary, 12 May. 2021, https://afribary.com/works/determination-of-the-state-of-stress-between-adhesively-bonded-single-lap-joints. Accessed 05 Nov. 2024.
JEROME, OLOTO . "Determination Of The State Of Stress Between Adhesively Bonded Single Lap-Joints.". Afribary, Afribary, 12 May. 2021. Web. 05 Nov. 2024. < https://afribary.com/works/determination-of-the-state-of-stress-between-adhesively-bonded-single-lap-joints >.
JEROME, OLOTO . "Determination Of The State Of Stress Between Adhesively Bonded Single Lap-Joints." Afribary (2021). Accessed November 05, 2024. https://afribary.com/works/determination-of-the-state-of-stress-between-adhesively-bonded-single-lap-joints