Machining of nickel-base, Inconel 718, alloy with ceramic tools under finishing conditions with various coolant supply pressures

Abstract

Machining of Inconel 718 with whisker reinforced ceramic tool gave better performance in terms of tool life under high-pressure coolant

supplies up to 15MPa compared to conventional coolant supplies. The use of 15MPa coolant supply pressure tend to suppress notching

during machining thus improving tool life, while the use of higher coolant supply pressure of 20.3MPa did not show improvement in tool life

due probably to accelerated notch wear caused by water jet impingement erosion. Cutting forces decreased with increasing coolant supply

pressure due to improved cooling and lubrication at the cutting interface as well as effective chip segmentation ensured by the momentum of

the coolant jet. Surface roughness generated were well below the rejection criteria. This can be attributed to the round shape of the insert which

tend to encourage smearing of the machined surface with minimum damage. Microstructure analysis of the machined surfaces show evidence

of plastic deformation and hardening of the top layer up to 0.15mm beneath the machined surface as a result of increase in dislocation density.

Overall Rating

0

5 Star
(0)
4 Star
(0)
3 Star
(0)
2 Star
(0)
1 Star
(0)
APA

Ezugwua, E (2021). Machining of nickel-base, Inconel 718, alloy with ceramic tools under finishing conditions with various coolant supply pressures. Afribary. Retrieved from https://afribary.com/works/machining-of-nickel-base-inconel-718-alloy-with-ceramic-tools-under-finishing-conditions-with-various-coolant-supply-pressures

MLA 8th

Ezugwua, E.O. "Machining of nickel-base, Inconel 718, alloy with ceramic tools under finishing conditions with various coolant supply pressures" Afribary. Afribary, 23 Apr. 2021, https://afribary.com/works/machining-of-nickel-base-inconel-718-alloy-with-ceramic-tools-under-finishing-conditions-with-various-coolant-supply-pressures. Accessed 23 Nov. 2024.

MLA7

Ezugwua, E.O. . "Machining of nickel-base, Inconel 718, alloy with ceramic tools under finishing conditions with various coolant supply pressures". Afribary, Afribary, 23 Apr. 2021. Web. 23 Nov. 2024. < https://afribary.com/works/machining-of-nickel-base-inconel-718-alloy-with-ceramic-tools-under-finishing-conditions-with-various-coolant-supply-pressures >.

Chicago

Ezugwua, E.O. . "Machining of nickel-base, Inconel 718, alloy with ceramic tools under finishing conditions with various coolant supply pressures" Afribary (2021). Accessed November 23, 2024. https://afribary.com/works/machining-of-nickel-base-inconel-718-alloy-with-ceramic-tools-under-finishing-conditions-with-various-coolant-supply-pressures