The main aim of any electric power supply in the world is to provide uninterrupted power supply at all times to all its consumers. Although, in developing countries, the electric power generated to meet the demands of the growing consumers of electricity is insufficient, hence power instability and outage.
Power instability or outage in general does not promote development in the public and private sector. The investors do not feel secure to come into a country with constant or frequent power failure. These limit the development of industries. In addition, there are processes that cannot be interrupted because of their importance for instance, surgery operation in hospitals, transfer of money between banks and lots more.Power instability and outage in developing countries (Nigeria) creates a need for alternative sources of power to backup the mains supply.
Automatic changeover switches find a wide application scope wherever the reliability of electrical supply from the utilities is low and it is used in lighting/motor circuits wherever continuity of supply is necessary, for switching to an alternative source from main supply and vice versa.
This project is a design of an automatic changeover switch. This means that when there is any mains failure, the automatic changeover switch will change to an alternative power supply (Generator), and back to the main supply when it is restored.
The purpose of this project is to maintain constant supply to the main circuit that is being supplied by making-up for the time lapse or delay that usually accompanies the manual switching from one source to another.
The design comprises of the power connection circuit and control connection circuit. The main components to be used include; contactors, relays and timer.
TABLE OF CONTENT
Table of Content
Chapter One: Introduction
1.1 Project Aims and Objectives
1.2 Target Beneficiaries.
Charter Two: literature Review
Chapter Three: Design of an Automatic Changeover Switch
3.1 Problem statement/Design problem
3.2 Relevance of project
3.3 Method of solution/Design procedure
3.4 Theory of devices
Chapter Four: Components selection and computational results
4.1 Selection of components
4.4 Discussion of results obtained
Chapter Five: Conclusion and Recommendation
Disclaimer: Note this academic material is intended as a guide for your academic research work. Do not copy word for word. Note: For Computer or Programming related works, some works might not contain source codes
CITE THIS WORK
(2012, 11). Design And Construction Of An Automatic Changeover Switch.. Afribary.com. Retrieved 11, 2012, from https://afribary.com/read/225/design-and-construction-of-an-automatic-changeover-switch
"Design And Construction Of An Automatic Changeover Switch." Afribary.com. 11 2012. 2012. 11 2012 <https://afribary.com/read/225/design-and-construction-of-an-automatic-changeover-switch>.
"Design And Construction Of An Automatic Changeover Switch.." Afribary.com. Afribary.com, 11 2012. Web. 11 2012. <https://afribary.com/read/225/design-and-construction-of-an-automatic-changeover-switch>.
"Design And Construction Of An Automatic Changeover Switch.." Afribary.com. 11, 2012. Accessed 11, 2012. https://afribary.com/read/225/design-and-construction-of-an-automatic-changeover-switch.
- Related Works
- Construction Of Microcontroller Dot Matrix Display System
- Construction Of A Microcontroller Based Gate
- Design And Construction Of An Electronic Attendance Staff Register (ear).
- Electrical Power Generating Systems Considering Renewable And Non-renewable Energy Sources Nigeria As A Case Study
- Construction Of A Microcontroller Based Security Door Using Smart Card
- Design And Construction Of Microcontroller Based Domestic Remote Control System
- Design And Construction Of An Automatic Voltage Stabilizer
- Construction Of Automatic Change Over Switch
- Use Of Solar Energy Rather Than Electric Energy To Charge Cell Phone
- Construction Of Automatic Water Level Controller For Both Overhead And Underground Tanks