An open-source 3-D printable laboratory sample rotator mixer is developed here in two variants that allow users to opt for the level of functionality, cost saving and associated complexity needed in their laboratories. First, a laboratory sample rotator is designed and demonstrated that can be used for tumbling as well as gentle mixing of samples in a variety of tube sizes by mixing them horizontally, vertically, or any position in between. Changing the mixing angle is fast and convenient and...
Recent advancements in open-source self-replicating rapid prototypers (RepRap) have radically reduced costs of 3-D printing. The cost of additive manufacturing enables distributed manufacturing of open source appropriate technologies (OSAT) to assist in sustainable development. In order to investigate the potential this study makes a careful investigation of the use of RepRap 3-D printers to fabricate widely used Black Mamba bicycle components in the developing world. Specifically, this study...
Lowcost gas metal arc welding (GMAW)based 3D printing has proven effective at additive manufacturing steel and aluminum parts. Early success, however, was based on handwriting Gcode, which is inadequate for the majority of potential users. To enable automated slicing a 3D model and generating Gcode for an acceptable path for GMAW 3D printing, this paper reports on upgrading of the free and open source CuraEngine. The new slicer, MOSTMetalCura, provides the following novel abil...
Solar powered systems have been built for various applications ranging from public lighting to water supply units but robust efforts have not been made in the development of pumping systems that can effectively replace the manually operated pumps used in field applications. Designing a machine that can pump the fluid without the need of so much energy on the part of the operator as well as boycott the use of direct electricity will hence be a reasonable contribution to field of maintenance an...
Abstract: Inhibition of corrosion on AISI 4137 steel in H2SO4 using Cascabela thevetia and Jatropha curcas leaves as inhibitor was studied using gravimetric and gasometric analysis. It was found that the leaves extract of both plants act as a good corrosion inhibitor for AISI 4137 steel in all concentrations of the extract ranging from 0.3 - 1.5 g/l and the inhibitive efficiency increases with increasing concentration of inhibitor. Cascabela thevetia has better surface coverage than J...
ABSTRACT The importance of Brushless Direct Current (BLDC) motors in modern day technology cannot be overemphasized. Its improved performance in terms of efficiency, reliability, noise and dynamic response, better speed versus torque characteristics, higher speed range, and durability over the Brushed Direct Current motors could not be wished away. This work investigates the performance of a BLDC motor with the application of PI controller, PD controller, PID controller, and fuz...
A model to predict the dry sliding wear behaviour of Aluminium-Jute bast ashparticulate composites produced by double stir-casting method was developed in termsof weight fraction of jute bast ash (JBA). Experiments were designed on the basis ofthe Design of Experiments (DOE) technique. A 2k factorial, where k is the number ofvariables, with central composite second-order rotatable design was used to improvethe reliability of results and to reduce the size of experimentation without loss ofacc...
Abstract. This research focuses on the design, fabrication and performance evaluation of a laboratory hot mounting press machine for metallography using locally sourced materials and indigenous technology. To achieve this research objective, working drawings were produced which were used to produce the parts of the machine. Mild steel plates were used for the housing and the movable platen while stainless steel and mild steel rods were used for the production of the mold and the stu...