This paper presents a comprehensive analysis of power flow and fault scenarios in a complex power system configuration consisting of generators, transformers, transmission lines, buses, and loads. Utilizing MATLAB's Power System Analysis Toolbox (PSAT) and employing the Newton-Rhapson Method, power flow calculations were conducted to assess system performance under normal operating conditions. Subsequently, fault analyses, including Double Line-To-Ground Fault (DLG) and Three-Phase Fault (3φ...
Abstract: Due to human influence and its negative impacts on the world’s environment, the world ischanging into a cleaner and more sustainable energy system. In both private and public buildings, there isa desire to reduce electricity usage, automate appliances, and optimize the electricity usage of a building.This paper presents the design and implementation of a secured smart home switching system based onwireless communications and self-energy harvesting. The proposed secured smart home...
Abstract: This study describes a DC to DC voltage multiplier using the 555 Integrated Circuit (IC) timer in an astable state. The major motivation of the design is to be able to produce an inexpensive and light form of generating high DC voltage to power devises that would normal need a really large and heavy battery to be operated. The study also briefly touch on the negative aspects of large DC voltage, heat dissipation and general battery life. With the help of the astable state of the mu...
Abstract: This paper presents the design and simulation of an Automatic Room Heater Control system. This system allows the user to set a desired temperature which is then compared to the room temperature measured by a temperature sensor.With the help of a micro controller, the system responds by turning ON any of the two (2) loads (Fan or a heater) automatically depending on the temperature difference. The Fan is triggered ON when the room temperature is higher than the set temperature and t...
Abstract: Improving Available Transfer Capability is an important issue in the deregulated power systems. The Available Transfer Capability of a transmission network is the transfer capabilities of a transmission network for the transfer of power for further commercial activity, over and above already committed usage. It is a proven fact that Flexible Alternating Current Transmission System technology can control voltage magnitude, phase angle, and circuit reactance. Therefore, it is importa...
Abstract: The reactive power compensation in power system is done by using different Flexible AC Transmission Controllers (FACTS). Unified Power Flow Controller (UPFC) is simulated and analyzed to observe its overall functions when integrated into a transmission line. It is installed in electric transmission lines hence assisting in the controlling and manipulating of the power flowing in the lines to give out reliable, controlled and efficient electricity to an ordinary consumer. The modell...
Abstract: Global Navigation Satellite System Reflectometry (GNSSR) can be used to derive information about the composition or the properties of ground surfaces, by analyzing signals emitted by GNSS satellites and reflected from the ground. If the received power is measured with linearly polarized antennas, under the condition of smooth surface, the reflected signal is proportional to the modulus of the perpendicular and parallel polarization Fresnel coefficients, which depend on the incidenc...
Abstract: The use of the millimeter wave (mmWave) spectrum and further exploration of sub mmWave has led to a new era in wireless communication, as the need for higher data rates grows. High frequencies, on one hand, incur a higher path loss, requiring an increase in antenna gain requirements. Metasurfaces, which emerge as a promising technology for mitigating path loss effects by utilizing 2D arrays of engineered meta-atoms resembling metamaterials that control the surface’s electromagnet...
Abstract: Amidst escalating data traffic demands, the fifth generation (5G) of mobile communication has been launched to curb these demands by providing high data rates, decreased latency, increased network capacity and large bandwidth. The ambitious performance expected from the 5G cellular communication network is enabled by different key technologies including shifting towards the millimeter wave frequency band. However, the millimeter wave band is accompanied by limitations of signal pat...
Abstract: This paper presents the design and implementation of Modular Multilevel Inverter (MMI) to control the Induction Motor (IM) drive using intelligent techniques towards marine water pumping applications. The proposed inverter is of eleven levels and has the ability to control the speed of an IM drive which is fed from solar photovoltaics. It is estimated that the energy consumed by pumping schemes in an onboard ship is nearly 50% of the total energy. Considering this fact, this paper ...
Abstract: This paper reports the experimental investigation of the corona discharge activity of punga oil under the influence of a local magnetic field and different voltage profiles (AC and DC voltages) using fluorescent fiber sensor as well as UHF sensor technique. The corona inception voltage (CIV) of punga oil is higher under negative DC voltage followed by positive DC and AC voltage, with a marginal reduction in its CIV magnitude observed on the impact of external magnetic field. The do...
Abstract: In visible light communication(VLC),arrays consisting of a single or multi-colour light sources are employed for a dual purpose being: the provision of illumination and data transmission. Therefore, it is substantial to come up with efficient techniques for resource allocation. The aim of this thesis is to design and develop a multi-user colour-based optical spatial modulation VLC framework using a line-of-sight (LoS) model. An optimisation problem with the intention of minimising...
Abstract: Solar energy is an abundant and clean resource. However, solar energy applications face challenges of low efficiency and high capital investments. To mitigate low efficiencies, electro-mechanical trackers that follow the sun path to enhance reception of solar energy are used. Usually these devices are complex in design. In this study, a simpler and less energy consuming dual axis solar tracker concept is designed and evaluated. A design process model consisting of the three main ph...
Abstract: Natural Esters (NEs) with a high proportion of Unsaturated Fatty Acids (UFAs) were used in this research. A Superior Insulating Fluid (SIF) is prepared by blending NEs like Baobab Oil (BAO) and Mongongo Oil (MGO) with a pure dielectric like Kerosene (KER) and subjected to ultrasonic wave treatment at 30 kHz. Then, accelerated heating of SIF is carried out in the presence of Kraft Paper (KP) and Copper Plate (CP) for 10 hours a day at 90 °C for 30 successive days. The deterioration...
This paper introduces a groundbreaking approach to revolutionize traditional farming practices by introducing a decision model-based agricultural electrical automation control system. The system integrates cutting-edge technologies, including artificial intelligence (AI), machine learning (ML), and sensor networks, with the goal of enhancing the efficiency and productivity of agricultural processes. By automating key tasks such as irrigation, fertilization, pest control, and harvesting, the s...