ABSTRACT The first part of this study discussed in details the two major model that was developed for the study of a multilayer reservoir system. They are the Dual permeability model proposed by Bourdet and the semipermeability wall model proposed by Gao. The pressure response of a crossflow system is observed in three stages; it behaves as a commingled system in the early stage and then as a single layer homogenous system in the late stage. There is a transition stage, which connects the ear...
ABSTRACT Despite its numerous benefits the search and production of crude oil poses a lot of dangers to the environment. Among these include land, water and air pollution. Prominent among the major sources of E&P waste is drilling operations which form the second largest source of waste after production activities. The major drilling wastes are drill cuttings, drilling mud and obnoxious gas emissions. These wastes are introduced into the environment through intentional as well as accidental ...
ABSTRACT The purpose of this work is to evaluate the uncertainty in the volumes of fluids in place in Fault Block A (Segment 3) of the G-1 Sands in the OND field located offshore Niger Delta. The evaluation was performed in three parts: (1) building of the static model and division into three hydrocarbon zones with reference to the oil-water-contact (OWC); (2) estimating the distribution of petrophysical properties such as porosity, water saturation and net-to-gross ratio in the reservoir an...
ABSTRACT Oil reserves are now located in hard-to-reach locations. This, combined with low oil prices, makes drilling for new reserves very expensive and risky. Enhanced oil recovery, which increases the amount of oil that can be recovered from a reservoir, should therefore be considered. This work uses numerical simulation to determine the suitability of gum arabic as a polymer for EOR operations. This was done by matching core-flooding experiments using Eclipse. Simulation gave a waterflood...
ABSTRACT The wellbore integrity plays an important role in petroleum operations like drilling, well completion and production. Caliper, Electrical image logs, Acoustic televiewers (ATV) and Optical televiewers (OTV) are some of the devices currently used in the industries to identify breakouts. However, these techniques are restricted in applications. For instance; caliper sometimes indicates the effect of drill spiral grooves as borehole enlargement zones, poor resolution, and complicated p...
ABSTRACT Determination of optimal well locations for infill drilling is a challenging task because engineering and geologic variables affecting reservoir performance are often nonlinearly correlated and have some degree of uncertainty attached to them. Numerical models which are the basis of well placement decisions rely on data that are uncertain, which in turn translate to uncertainty in our numerical simulation forecasts. The objective of this research is to employ an efficient optimizati...
ABSTRACT Without accurate estimation of annular pressure losses it is possible to face serious problems that would yield to interruption in drilling operation and sometimes lead to the abandonment of the well. Therefore, exact estimation of annular pressure losses is vital in drilling and well completion operations to control formation pressure and optimize drilling and completion fluids hydraulic program. Many investigators have proposed different equivalent diameter concept to provide a si...
ABSTRACT The research is aimed at the understanding of the various diagnostic plots for the analysis of water production that are available as well as the application of these methods in a case study. It also aimed at the establishment of a work flow for the evaluation of water production mechanisms. A workflow was developed that combines numerical simulation and diagnostic plots to analyze the water production performance in a reservoir. This workflow was validated using a case study. The m...
ABSTRACT Petroleum Fiscal System (PFS) is a major determinant of investment decision in the exploration and production of oil and gas in any country. It basically describes the profitability relationship between the host government of the producing community and the International Oil Companies (IOCs). The comparative analysis of the performance of the fiscal regimes becomes imperative as it affects the interest of the investor and the production of oil and gas. During the formulation of any ...
ABSTRACT Maximum production from an oil well can be achieved through proper selection of tubing size. The selection of optimum tubing size must be evaluated when completing a well in any type of reservoir especially solution gas drive reservoir since there is likelihood of producing more gas as the reservoir pressure declines. The most widely used methods such as Tarner, Muskat and Tracy methods for predicting the performance of a solution gas drive reservoir were discussed and used to estim...
ABSTRACT The practical application of various production parameters and relations to predict the well performance analysis of a solution gas drive reservoir is the primary objective of this study. These parameters include: IPR (inflow performance relation), OPR (outflow performance relation) and PI (productivity index). Theoretical data was used to predict the performance behavior of a solution gas drive reservoir from start of production till its abandonment. IPRs and OPRs were developed du...
ABSTRACT Petroleum fiscal regime defines the extent to which the host government and the prospective investor can apportion risks and share project rewards. Ghana’s petroleum industry has become an attractive place for most investors because the current fiscal regime governing the industry is based on old petroleum tax laws and systems. In this study the petroleum fiscal regime currently used in Ghana was modelled, reviewed and evaluated. A proposed progressive fiscal regime was then put f...
ABSTRACT This study presents an investigation of the hydrodynamics behaviour of slug flow in an inclined (80 degree inclination) and 67 mm internal diameter pipe. The study provides a more rudimentary explanation into the physical phenomenon that controls slug flows behaviour and the way these parameters behave under variable flow conditions. Various correlations for determining slug characterisation parameters have also been presented and validated with the experimental data. The slug ...
ABSTRACT A new method for analysing productivity index (PI) on vertical wells is the main objective of this study. Well performance is often measured in terms of the well’s productivity which is dependent on a number of factors such as the reservoir’s configuration, the type of completion, petrophysical and fluid properties, formation damage, etc. The effect of partial completion is the main focus of making the productivity index analysis since almost all vertical wells are partially com...
ABSTRACT From the inception of the oil and gas industry, water production has always been an aching problem for various operators. Throughout the productive life of a field, oil production is often accompanied with some amount of water production, which in most cases, is so significant and unwanted. Because of the great operating, environmental and economic challenges associated with excess water production, operators are in search for different methods and tools that could be used to identi...