Design and implementation of CGPA using visual basic

40 PAGES (1000 WORDS) Computer Science Project
Subscribe to access this work and thousands more
ABSTRACT
The end-of-course grades assigned by lecturers are intended to convey the level of 
achievement of each student in the class. These grades are used to make a multitude 
of decisions. Unless a sufficiently, accurate and efficient method is used for the 
grading, the grades are applied to convey misinformation and lead the decision-
maker astray. In itself, the processing of results is found to be rather tedious, 
especially when carried out manually, and when the number of students is large. It is 
time-consuming and error prone. The process, however, becomes a lot easier and
much more accurate when carried out with a computer running a suitable software 
application. To find a sufficiently fast and accurate method of carrying out this 
processing is a problem that is both challenging and interesting. In this work, a 
computer software application was developed to facilitate the automated processing 
of the results. The software was developed in visual basic programming language. 
The developed software performed well and produced expected results on 
completion. With it, it was possible to compute Grade Point Average and 
Cumulative Grade Point Average for each student based on examination scores entered

CHAPTER ONE
Introduction

CHAPTER TWO
Literature Review

CHAPTER THREE
RESEARCH METHODOLOGY

CHAPTER FOUR
Design Presentation

CHAPTER FIVE
GENERAL CONCLUSION
SUMMARY/CONCLUSION.........
RECOMMENDATION............... 
References
Subscribe to access this work and thousands more