1. Home
  2. Browse Works
  3. Engineering
  4. Electrical Electronics Engineering
  5. THE DESIGN AND IMPLEMENTATION OF ELECTRONICS SE...

THE DESIGN AND IMPLEMENTATION OF ELECTRONICS SEQUENTIAL SIGN PATTER DISPLAY

38 PAGES (4169 WORDS) Electrical Electronics Engineering Project
Subscribe & Access
Subscribe to access this work and thousands more
ABSTRACT
This design implementation of this electronic sequential sign post display employs the use of some specialized components. This section of the project introduces the reader to the different section of the project and the components that makes them up.
Emphasis are laid on describing the behaviour and operational system of the components as related to the project modeling, analysis, design and implementation of an ELECTRONIC SIGN POST, which is made up of a power supply, a shift register, a counter, multivibrator (555CMOSI.C) transistor, relay, resistors of different ohmic values capacitors, sensitive mic (for the switching system) and 220V AC lamp.


TABLE OF CONTENTS
Title Page 
Declaration 
Approval Page
Dedication 
Acknowledgements
List of Table 
List of Figure 
Table of Contents 
Abstract 
Description/Functions of Components Used with 
List of Figures

CHAPTER ONE 
Introduction 

CHAPTER TWO 
Literature review

CHAPTER THREE
Methodology 

CHAPTER FOUR 
Power supply
Rectification 
Filtration 

CHAPTER FIVE 
Design of sequential Counter 

CHAPTER SIX 
Design of the transistor/Relay Drive 

CHAPTER SEVEN 
Design of system timing circuit 
Design of an interated timing circuit 
Astable multivbrator 
Asignchronous counter 
Synchronous counter

CHAPTER EIGHT 
Construction and packaging 
Packaging 
Problem encountered and solutions 
References 

Subscribe to access this work and thousands more
Subscribe & Access
Related Works

Privacy Policy | Refund Policy | Terms | Copyright | © 2024, Afribary Limited. All rights reserved.