Predicting the Effect of Well Trajectory and Production Rates on Concurrent Oil and Gas Recovery from Thin Oil Rims.

Subscribe to access this work and thousands more

Thin oil rim reservoirs are those with less than a 100 ft. of oil thickness underlain and
overlain by an aquifer and gas cap respectively. Irrespective of the sizes of the aquifer or gas cap,
oil rims productivity is usually low due to excessive coning of water and gas. Production
optimizations are usually carried out before recovery schemes are initiated. One of such is a
concurrent oil and gas production which is used in comparison with sequential production in this
study in conjunction with production rates and well geometry to ascertain the extent of recovery
and to improve the overall field development plan. Production of gas is slightly restricted to meet
gas demands and also to prevent an adverse effect on oil production. A case study of an oil rim
from the Niger delta was studied by running reservoir simulation using Eclipse software to check
the effect of production schemes, well type and production rates on oil recovery. From the
studies, concurrent production using a horizontal well and a production rate of 1000 stb/day is
desired for an appreciable incremental oil recovery Further studies on limiting oil rim movements
and thusly increasing oil recovery can be done by initiating secondary and enhanced oil recovery
schemes.


Subscribe to access this work and thousands more