ABSTRACTThis project was done to extract and characterize bean oil according to their particle sizes. The experiment was carried out using scent bean (i.e. ‘Ozaki’, ‘Ijilizi’or ‘Azamu’) as sample. The oils were extracted by solvent extraction /leaching extraction using n-hexane. Proximate analysis was carried out to obtain percentage moisture content, ash content, total oil content, protein content and carbohydrate content of the extracted oils. From observation, it was noticed th...
ABSTRACTThis study is a comparative analysis of the use of coal, fuel oil and natural gas for cement production noting their physical and chemical properties, cost and availability, impact on the environment and human health. Out of the seven cement manufacturing industries in Nigeria, three industries use these fuels were selected for the study. The industries are NigerCem –Ebonyi state, Dangote cement –Benue state and UniCem -Cross river state. Questionnaires were used to gather informa...
ABSTRACTActivated carbon, also widely known as activated charcoal or activated coal is a form of carbon which has been processed to make it extremely porous and thus to have a very large surface area available for adsorption or chemical reactions (Mattson et al., 1971). The word active is sometimes used in place of activated. It is characterized by high degree of micro porosity. A gram of activated carbon can have a surface area in excess of 500 m2. Sufficient activation for useful applicatio...
ABSTRACTBiomass, particularly agricultural residues seem to be one of the most promising energy resources for developing countries (Patomsok, 2008). Rural households and minority of urban dwellers depend solely on fuel woods (charcoal, firewood and sawdust) as their primary sources of energy for the past decades (Onuegbu, 2010). Of all the available energy resources in Nigeria, coal and coal derivatives such as smokeless coal briquettes, bio-coal briquettes, and biomass briquettes have been s...
ABSTRACTThe project “microcontroller based intelligent traffic light system with automatic street light and warning light” was designed to tackle the traffic issues in the country so as to establish automatic traffic control and monitoring system with near perfection. The project intelligent traffic light with automatic street light and warning light is a complex microcontroller based project that was designed to control traffic on a four way road network.The system is embedded with sens...
ABSTRACT A comparative study was conducted among organic waste materials namely coconut fiber, hair, sawdust and woodchips as crude oil absorbents. Twenty grams of each of these materials were wrapped in a pouch and submerged into two set-ups, Set-up A: Pure Crude Oil and Set-up B: Crude Oil with seawater, for an hour. Amount of oil absorbed was gathered and recorded. ANOVA was conducted to verify if the results significantly differed. The results show that hair had the highest amount of ab...
ABSTRACT The research project studies the analysis of pear and its oil. The mesocarp from edible African pear “DacryodesEdulis” were evaluated for their oil yield. The pulp from this pear were oven dried at 100oC-105oC to a moisture content level of 29%.The mesocarp was subjected to proximate analysis to determine the percentage of the moisture, ash, fat, crude fibre, crude protein and carbohydrate content which resulted to the values of 29%, 2%, 19.6%, 25.5%, 11.9%, and 12% respectively....
INTRODUCTION A public address system is an electronics sound amplification and distribution system with a microphone, amplifier and loud speaker used to allow a person to address a large public. The public address system consists of three main parts namely, the microphone (input transducer), amplifier and the loudspeaker (output transducer). The microphone picks up the sound and convert it to electronic signal in milivolts and this is fed to the amplifier for amplification. In this project, a...
ABSTRACT As the name of the project implies “Automatic Emergency Light” is an electronic system that can provide light during emergency situations i.e when mains (NEPA) supply fails. This system can provide enough light with full brightness in a given room or office. The system makes use of white light emitting diodes for the lightings. It is automatic in operation, in the sense that it can switch itself off when the battery charges full. Automatic Emergency light comprises three s...
ABSTRACT As the name of the project implies “Power Inverter”, is an electronics system that converts DC Energy (voltage) to an AC energy. The major aim of this project is to design and construct a 1000VA Power inverter that is capable of powering loads of equivalent ratings, in the absence of power supply from NEPA or Generator. The system (power inverter) consists of the AC mains sensor section, Relay/change over section, Battery charger section, oscillator section, Driver section, out...
ABSTRACT Air pollutions pollutant showed that the extent of spreading depends on the motor vehicle traffic population of the area. This pollution strongly generated through combustion of fossil fuels presents difficult environmental challenge to societies as it could degrade the environment and affect human health and quality of life. Vehicular emissions are major contributors to air pollution in urban areas as they contain harmful gases. The levels of carbon monoxide has been investigated in...
ABSTRACT Flooding has been described as one of the most important environmental factors determining the distribution of salt marsh plants. We studied the impact of five water levels on the germination and establishment of the invasive cord-grass spartina deniflora. Plant house experiment was carried out to determine the effects of time and depth of flooding on the survival and growth of rice. Data showed that time and depth of flooding had significant effects on the survival and growth of ric...
ABSTRACT The microbiological and organic pollutants characteristics of umuosoko stream in ikwuano local government area, Enugu state, Nigeria were carried out. Twenty water samples were collected from four different parts of the river. The pour plate technique was employed for the isolation of micro-organisms. Colonial morphology, Gram staining and biochemical tests were used for identification and characterization. The statistical analyses used were analysis of variance and standard devia...
INTRODUCTION The purpose of a control system is to produce a desired output. This output is usually specified by a command input, and is often a function of time. For simple applications in well structured situations, to control, and the controller must have the capability of reacting to disturbance, changes in its environment, and new input commands. The keys element that allows a control system to do this is feedback, which is the process by which a system’s output is used to influence ...
INTRODUCTION Communication means extending information form one person to another in a way in which it can be understood. Information and ideas in technical and scientific fields can very often be more easily communicated through sketching or instrument drawing and blueprint reading. Drawing involves describing the shape and size of an object. CHAPTER ONE Preambles Types of Engineering Drawings CHAPTER TWO 2.1STAGES IN THE DEVELOPMENT OF A NEW PRODUCT 2.2THE DRAWING OFFICE 2.3PRINT ...