ABSTRACT Water Purification Unit or filtration unit is designed in way that it will give a nice result. Like in our filtration, we have sand and carbon filter that were responded to separate the suspended solid particles, odour and taste of the water, which will give a very nice filtered water at the end of the filtration. This unit has no chemical engineering operation, but a physical separation process that will separate the dead micro organisms and the task, colour odor of the water. ...
ABSTRACT The major aim of this project research work is to produce emulsion paint from locally sourced pigment & extenders. The materials used for the production was of local source. The major raw materials used for the production of the emulsion paint: water, titanium iv oxide, calcium carbonate, kaoline, calgon, natrosol, biocide P.V.A, ammonia, deformer (Ginap) kerosene, yellow iron oxide and red iron oxide. Emulsion paint of two (2) samples was produced, and calcium carbonate locally obt...
ABSTRACT The refurbishment of the fluid flow demonstration unit was carried out in the Chemical Engineering pilot plant laboratory of the Institute of Management and Technology Enugu. The refurbishment process was carried out to ensure adequate functioning of the unit, to allow the continuous use of equipment in the pilot plant, so that student would use it in understanding the nature of the flow of fluid through pipe lines, these process was also for the development of the knowledge of ever...
ABSTRACT The construction of the five (5) litre Electric Kettle was carried out in mechanical workshop of the Institute of Management and Technology Enugu. (I.M.T). The fabrication process, included measuring and marking out operations of which the following dimensions was taken; the cylindrical body was taken as 170mm by 700mm in height and length respectively, the base diameter was 223mm, the lid diameter 140mm, length of nozzle 75min, water outlet and inlet were 20mm and 35mm, respectivel...
ABSTRACT This project was carried out using coal sample from Onyeama coal mine Enugu, Enugu State. Activated coal was produced by carbonizing the coal and activating it using phosphoric acid at a temperature of 5500c. the degree of bleaching of raw palm oil was monitored using spectronic meter through absorbance measurement. The essence was to identify suitability of the coal as a bleaching agent on palm oil. Comparison of the result obtained was made with the commercial fuller�...
ABSTRACT The repair of the fixed bed adsorption column, a product of arm field technical company was carried out for the purpose of bringing the faulty equipment back to its normal operating system. Before this exercise, the equipment was out of operation because of the completely blocked base of the fixed bed column (water column) and the malfunctioning of the air control value. The sintered bronze plate which formed the base of the water column was cleaned up and freed from debris which or...
ABSTRACT This project is aimed at producing black and brown polish of good quality. For clearity, polish is a substance rubbed on the surface of materials to make them smooth and shiny. Polish has being of immense importance in protecting leather surfaces and enhancing their beauty. To produce a standard polish, hard waxes such as carnduba wax, candelhla wax and palm wax; semi-hard waxes which include, paraffin wax and ozokerite; solvents like tupentine and naphtha; dyes and dryers are ess...
ABSTRACT The project aims to develop a flow process to obtain the optimum temperature and time necessary for the maximum recovery of alkali present in palm inflorescence. On this ground, a preliminary experiment was performed. During this process, both male and female palm inflorescence were compared for maximum alkali production and it was observed that the female palm inflorescence produced highest quantity of alkali than the male palm inflorescence. Based on this, the female palm infl...
ABSTRACT The need for an authentic and reliable report relating to the modification of a proto-type air-conditioning unit is inevitable. Many homes and offices use the air conditioner to cool the temperature in their respective homes and offices, so the maintenance of the air conditioner should be a top priority of every individual in order to avoid huge expenditure in the modification of the system. This report began with an introduction into the relevance of an air conditioner, the gener...
ABSTRACT The production of the soap was carried out using all the necessary equipments like the reactor, mould, stirrer, hygrometer guage etc. and all the required reagents for soap production in correct proportion. In the production, palm kernel oil (P.K.O) was used instead of tallow or grease. This was because soap produced from grease or tallow tends to dissolve slowly at room temperature, whereas, soap of palm kernel oil product gives a quicker lather which is relatively suitable. Diff...
ABSTRACT The candle mould has twenty four (24) holes which could produce twenty four (24) quality candle sticks Aluminum, a non ferrous metal was used as the construction material for the mould the type of casting technique used was green sand mould method. In the process of moulding the pattern was placed in the flask which contained the green sand. The flask was turned upside down and the reverse side of the pattern was formed. This part is called the positive part, the other part of t...
ABSTRACT This project is an equipment which been fabricated for the principle purpose of producing heat energy for commercial use by burning solid fuel like briquette. The project which is the fabrication of briquette stove was made from preferentially selected engineering materials like mild steels of different gauge member and metallic rod. These metallic materials posses some mechanical properties like malleability, ductility, static strength and have the capability of with standing ...
ABSTRACT Interface on petroleum product in multi-purpose pipeline system refers to as the zone of demarcation between two products where mixing occurs. Generally, interface is a boundary layer, so the boundary between two products when they are pumped in succession is known as interface. In Nigeria Petroleum Industries like NNPC (PPMC) make use of multi-purpose pipeline system. This is where interface comes in petroleum products. Interface as defined above plays a lot of economics import...
ABSTRACT The aim of this project was to construct one office table and four chairs. In the course of this project the length of plank used was 12†and we used about 4 number (mahogany) of 1†thickness, ¾ plywood of 1 sheet of 1†thickness, as well as ¼†plywood of ½ and glue 1 tin wenner 1 rod, foam ½ sheet. Fabrics 4 years, spraying materials and 21b of nail were utilized to effect the construction of office table and chairs. The materials were marked out t...
ABSTRACT The purpose of the construction is aimed at producing heat energy for commercial use by turning liquid fuel(kerosene).the construction was successful by appropriate selection of engineering material favourably mild steel(blacksheet) and steel iron for special p2rts. The technological properties passed by the chosen mild steel are; machinability ,weldability,durability,andformability.mech2nude properties includem2llebillity,duetility,st2tic strength and high tensile strength . The se...