ABSTRACT The effect of concentration of hydrochloric acid on hydrolysis of cellulose (saw-dust) to glucose was studied on this research project and the steps obtained to achieve this project involved treatment of saw-dust (cellulose) with different concentrations of the acid at constant temperature of 80° (350k) for 30mins. This was followed by glucose analysis, some analysis or experiments were done on acid hydrolysis in order to study the effect of (HCL) acid on the hydrolysis of cellulose...
The major aim and objective of this design [of a patient heartbeat and temperature monitor using RF.] is to help the doctors and family members to keep track of the heartbeat condition of their loved ones [as well as their body temperature] in the case of an abnormality in the health condition (for those with heartbeat defects and those that run excessive high temperature beyond normal). If any varied change takes place, it is notified. This notification through RF. Channel would to take an a...
ABSTRACT The advantage of cellular communication like GSM technology is a potential solution for such remote controlling activities. GSM-SMS technology can be used to control household appliances from remote places. Remotely, the system allows the home owner to monitor and control his house appliances via his mobile phone set by sending commands in the form of SMS message and receiving the appliances status as well. This system provides ideal solution to the problems caused in situations when...
ABSTRACT A comparative investigation was undertaken to determine the head loss coefficients for horizontally mounted and vertically mounted orifices using a Fluid mechanics and Heat transfer trainer developed in Nigeria. Experiments were carried out observing the procedure and the discharge of the flow of water was collected to obtain the volumetric flow rate and also read off the right and left limb of the horizontal and vertical manometers at different set points. The experimental measureme...
The scope of the project covers aspects like the features of automatic three phase selector, its applications, and its operations. Its advantages and its components. Finally, it covers the importance on the need of automatic three phase selector and contributions toward a greater sharing load balance and a better three phase power distribution and monitoring for domestics consumers. INTRODUCTION As the growing population of human race widens the gulf between energy supply and energy demand, ...
The main aim and objective of this project is to design and build and arc welding machine that operates on 36vdc at variable frequency which of benefit to urban area. This reduces the weight and size of the transformer use for welding. To have an arc welding machine that is more efficient which produce neat welding. INTRODUCTION Welding is a way of heating pieces of metal using electricity or a flame so that they melt and stick together. It can simply be defined as the process of joining two...
ABSTRACT It has become inevitable that there would be communication and due to the inherent limitation of the human voice, the public address system came to being. A public address or “P.A SYSTEM” is an electronic amplification system with a mixer ,amplifier and loudspeakers, used to reinforce a given sound , e.g a person making a speech, pre-recorded music ,or message and distributing the sound throughout a venue . The voice signal is passed through a microphone , which converts the sou...
This project is mainly intended to prevent the usage of mobile phones in places inside it coverage without interfering with communication channels outside it range, thus providing a cheap and reliable method for blocking mobile communication in the required restricted area only. Although we must be aware of the fact that nowadays lot of mobile phones can easily negotiate the jammer effect are available and therefore advance measures should be taken to jam such type of devices. The main disadv...
ABSTRACT Automatic water level controller for both overhead and underground tank is designed to monitor the level of water in a tank. It displays the level of water and when it is at the lowest level; a pump is activated automatically to refill the tank. When the tank is filled to its maximum capacity, the pump is automatically de-energized. Several circuits are put together to ensure proper working of this design, and the block diagram includes the supply unit, the micro-processor unit, the ...
ABSTRACT T-junction traffic light controller is such a device that will play a significant role in controlling traffic at junctions, to ease the expected increased rush at such junctions and reduce to minimum disorderliness that may arise, as well as allowing the pedestrians a right of the way at intervals rather than being struck down when in a hurry to cross the roads. Such an electrical system with a touch of electronics that control the flow of traffic in a pre-determined sequential patte...
ABSTRACT With advancement of technology things are becoming simpler and easier for us. Automatic systems are being preferred over manual system. The purpose of this project is to design and construct A GSM based home automation using AVR. Using GSM networks, in this project a home power control system has been proposed that will act as an embedded system which can monitor and control appliances and other devices locally using built-in input and output peripherals. The system has a delay of 2 ...
OBJECTIVE OF THE RESEARCH The aim of this research project is to determine and compare the performance of chemically and microwave synthesized activated carbon from corn cob. INTRODUCTION Activated carbon, also widely known as activated charcoal or activated coal is a form of carbon which has been processed to make it extremely porous and thus to have a very large surface area available for adsorption or chemical reactions (Mattson et al., 1971). The word active is sometimes used in place of...
The purpose of embarking on this study was to provide a well-detailed account on the impact of digitization of the Broadcasting Media in Nigeria. The study ascertained the level of media digitization in Nigerian Television Authority, Enugu (NTA) in this Era of ICT and internet operations. The researcher used survey research design to enable her determine the sample size which is 150 through the appropriate statistical method to represent the population of the study. Survey Research Method was...
The study aimed at the design, construction and performance evaluation of a model Waste Stabilization Pond (WSP). The WSP comprised of one facultative pond and three maturation ponds all in series. The influent of the WSP after filtration through the lined sandy loam media (obtained from the premises of Federal University of Technology, Owerri, Nigeria) had the BOD reduced to 22 mg/L from 356 mg/L indicating a 93.8% removal level. A faecal coli form count (fc) of the influent sample gave 1×1...
The study aimed at the design, construction and performance evaluation of a model domestic wastewater treatment plant was carried out. The treatment unit was a Waste Stabilization Pond (WSP) comprised of one facultative pond, three maturation ponds, and a contact filtration unit, all in series. The effluent of the WSP, after filtration through clay media, had the BOD reduced to 15.4mg/l, from 356mg/L indicating a 95.67% removal level. A Faecal Coliform (FC) count of the influent sample gave 1...