ABSTRACT Simplified predictive numerical models have been developed for diffusion rate of crude oil spilled into Niger Delta soils. The proposed model equations were developed using Fourier transformation, and Green’s function. The induction principles as well as the indicial matrix method of dimensional analysis were adopted in determining the functional parameters that could possibly influence their diffusion rates. These mathematical models correctly predict one – dimensional ...
ABSTRACT A data-driven approach to solving the problem of excess water production was the focus of this study. In this research, several reservoir models were simulated for 26 years, and data obtained after simulation was used to develop two artificial neural network models to predict the water cut for various producers. The first 22 years of data obtained from simulation was used to train the first neural network model, and the model was then used to forecast the water cut for the last four...
ABSTRACT New Biodegradable drilling fluids were developed using Brachystegia eurycoma (achi), Detarium microcarpum (ofo) and Pleurotus (osu). The drilling properties such as yield point, apparent viscosity, low shear rate yield point and fluid loss were determined.The field polymer muds that are currently in use namely; PAC-R and PAC-L were formulated and used as control samples to the new proposed product. Herschel –Buckley model was used to obtain the yield stress. Cutting transport rat...
ABSTRACT Waterflooding is the most dominant secondary oil recovery method and its popularity is mainly due to the general availability of water, the relative ease of injecting water, the ability of water to spread easily through an oil-bearing formation and the efficiency of water in displacing oil. However, waterflooding is not without its challenges. Factors such as reservoir heterogeneity, lateral and vertical variations in permeability and presence of discontinuities greatly affect this ...
ABSTRACT In this work, an expert system for energy management in community based microgrid was developed. This was necessitated in a bid to address the inadequate power supply predominant in sub-Saharan African countries, while also addressing the problem of energy wastage that comes from individuals supplying their own energy demands. To achieve this, an architecture for a microgrid network was developed by adopting existing standards in the geographical region of interest. An energy...
ABSTRACT Nigeria is endowed with huge proven gas reserves estimated to be 184 trillion cubic feet (Tcf). It ranks as the 7th holder of natural gas reserves in the world, and the largest in Africa. Nigeria also flares more natural gas than any other country; it accounts for 12.5% of the world‟s annual gas flared and it wastes $2.0 billion annually by flaring gas associated with crude oil extraction. There is crucial need to monetize the gas reserves, reduce gas flaring and its environmental...
ABSTRACT This thesis examines the development of a gas propellant rocket motor using cheap local materials. The fabrication of the prototype rocket engine was achieved by using machine tools like the lathe and drilling machines. The internal radius around the nozzle throat area was made without using any special tools for curves. The engine was tested twice and readings or data taken for pressure and temperature. Two thermocouples were damaged because the temperature exceeded their ...
ABSTRACT The development of a Cathodic Protection System for a mild steel pipe using a magnesium anode was investigated. The pipe was externally coated with three layers of polykene tape wrapping and the soil resistivity was determined using the Wenner four pin method; a value of 2177Ωcm was obtained. The design parameters for the developed Cathodic Protection System were: total current of 0.0153mA; current density of 0.01mA/m2; protection current of 0.0153mA; protection voltage of 0...
ABSTRACT Analytical models can be valuable tools to investigate solute transport in porous media. The application of analytical solutions is limited by the perception that they are too cumbersome to derive while their implementation rests on assumptions that are too restrictive. This research is aimed at understanding the effect of linear drift on radial transport of tracer in porous media. It provides an analytical Solution that expresses the Concentration Distribution around the source of ...
ABSTRACT A non-weighing lysimeter was designed, fabricated, tested and installed at Arochukwu, Abia State, Nigeria, where the farmers who engage in dry season vegetable production do so with no knowledge of irrigation water requirements. This method tends to either over-irrigation or under-irrigation below the vegetable water requirements. Too much water can leach costly fertilizers to depths below the root zone, where both the water and fertilizer are permanently lost. Too little water ...
ABSTRACT In this work, the operation and performance of a novel Separation Tray Column under Vertical and Tilt conditions is presented. The Tray Column used for the work is a Downcomerless liquid initiated and controlled Valve Tray with capacity to shut portions of the tray lacking liquid at any time. To evaluate the mass transfer performance of this column, an oxidation experiment was conducted at 300C and the percentage of Fe (II) oxidised to Fe (III) from contaminated water by air was ch...
ABSTRACT The theoretical study of methylammonium bismuth halide, (CH3NH3)3Bi2I9, was simulated using SCAPS 1D software package. The effect of the bismuth perovskite absorber layer thickness on the solar cell performance was investigated using three different materials (organic and inorganic) materials such as Cu2O, CuI, and spiro-OMeTAD as hole transporting layer (HTL), and four different materials (organic and inorganic) materials such as ZnO, TiO2, PCBM, and P3HT as electron transporting l...
ABSTRACT Optimizing the placement of new wells and well spacing is a vital issue in oil field development. Drilling infill wells is one way to maximize the recovery of oil from reservoirs. The problem of infill well placement is challenging because many different well scenarios must be evaluated when undertaking the optimization program and very often, the variables that affect reservoir performance are nonlinearly correlated with some degree of uncertainty. Using computational algorithms ha...
Abstract In the estimation of most reservoir parameters in well test, the reservoir is assumed to be isothermal which is practically not true due to the fact that there are heat sources due to friction in the wellbore, works done by the drill bit and in thermal recovery. Although, this temperature change is small, it can serve other beneficial purposes in the reservoir and wellbore. The research work used the temperature change to estimate permeability, skin factor and initial temperature of...
ABSTRACT Slug flow along slightly inclined horizontal pipes is a major problem in gas-liquid transportation, it is very pronounced in chemical, oil and gas processing industries. In reality, there is no absolute horizontal pipe due to the undulating nature/ Topography of the laid pipe terrains. Very little research has been done in this area because of lack of experimental data. This work is proposed to use raw experimental data from 10 degrees inclined horizontal pipe to analyze the flow pr...