Engineering

Research Papers/Topics Engineering

Determining Individual Characteristics Of A Twolayered Reservoir Using The Tds Technique.

ABSTRACT The first part of this study discussed in details the two major model that was developed for the study of a multilayer reservoir system. They are the Dual permeability model proposed by Bourdet and the semipermeability wall model proposed by Gao. The pressure response of a crossflow system is observed in three stages; it behaves as a commingled system in the early stage and then as a single layer homogenous system in the late stage. There is a transition stage, which connects the ear...

Estimation Of Drilling Wastes – An Environmental Concern While Drilling Oil And Gas Wells

ABSTRACT Despite its numerous benefits the search and production of crude oil poses a lot of dangers to the environment. Among these include land, water and air pollution. Prominent among the major sources of E&P waste is drilling operations which form the second largest source of waste after production activities. The major drilling wastes are drill cuttings, drilling mud and obnoxious gas emissions. These wastes are introduced into the environment through intentional as well as accidental ...

Evaluating Uncertainty In The Volumes Of Fluids In Place In An Offshore Niger Delta Field

ABSTRACT The purpose of this work is to evaluate the uncertainty in the volumes of fluids in place in Fault Block A (Segment 3) of the G-1 Sands in the OND field located offshore Niger Delta. The evaluation was performed in three parts: (1) building of the static model and division into three hydrocarbon zones with reference to the oil-water-contact (OWC); (2) estimating the distribution of petrophysical properties such as porosity, water saturation and net-to-gross ratio in the reservoir an...

Corrosion Behavior Of Epoxy (Sigmaline) Coated X65 Steel In Some Selected Corrosive Media

ABSTRACT Like any industry, the economic success of the oil and gas industry can be no swifter than its success in corrosion control/prevention. Some oil and gas industries operate in hostile offshore environment that harbors significantly quite substantially different corrosive agents including ions of chloride, Cl- , bicarbonate (HCO3 - ), hydrogen sulfide (HS- ), sulfide (S- ), etc., coupled with gases such as oxygen (O2), carbon dioxide (CO2), just to name a few. Oil and gas structural m...

Numerical Simulation Of Enhanced Oil Recovery Using A Gum Arabic Polymer

ABSTRACT Oil reserves are now located in hard-to-reach locations. This, combined with low oil prices, makes drilling for new reserves very expensive and risky. Enhanced oil recovery, which increases the amount of oil that can be recovered from a reservoir, should therefore be considered. This work uses numerical simulation to determine the suitability of gum arabic as a polymer for EOR operations. This was done by matching core-flooding experiments using Eclipse. Simulation gave a waterflood...

Quantifying The Risks Of Wellbore Failure During Drilling Operations Using Bayesian Algorithm

ABSTRACT The wellbore integrity plays an important role in petroleum operations like drilling, well completion and production. Caliper, Electrical image logs, Acoustic televiewers (ATV) and Optical televiewers (OTV) are some of the devices currently used in the industries to identify breakouts. However, these techniques are restricted in applications. For instance; caliper sometimes indicates the effect of drill spiral grooves as borehole enlargement zones, poor resolution, and complicated p...

Synthesis And Characterization Of Extruded Alkali Activated Earth-Based Composites For Sustainable Building Construction

ABSTRACT Alkali activation is a rapidly developing area in the global materials research and development community. It is based on alkali aluminosilicate chemistry with primary focus on the activation of solid aluminosilicate materials under alkaline conditions to produce three-dimensional network of inorganic polymer binders. However, little research has been conducted to harness this technology in the development of earth-based composites. This work provides insights on the application of ...

Evaluation Of In-Fill Well Placement And Optimization Using Experimental Design And Genetic Algorithm

ABSTRACT Determination of optimal well locations for infill drilling is a challenging task because engineering and geologic variables affecting reservoir performance are often nonlinearly correlated and have some degree of uncertainty attached to them. Numerical models which are the basis of well placement decisions rely on data that are uncertain, which in turn translate to uncertainty in our numerical simulation forecasts. The objective of this research is to employ an efficient optimizati...

Layered Composite Thin Films For Cost Effective Transparent Organic Solar Cell Electrodes

Abstract In this dissertation two main themes are explored. In the first part some phenomenologies of light transport across the ZnO/Al/ZnO (ZAZ) thin film multilayer structures are investigated. The multilayered ZAZ thin film composite structures are explored for potential applications as transparent electrodes (TEs) alternatives to the costly transparent indium-doped-tin-oxide (ITO) anodes that are used currently in organic solar cells (OSCs), organic light emitting devices (OLEDs) and var...

Radiological Safety Assessment Of The Ghana Research Reactor-1 At Shutdown Using Atmospheric Dispersion Model

A radiological safety assessment of the GHARR-1 was evaluated by calculating approximately the TEDE of radionuclides release from the reactor at shutdown using atmospheric dispersion model before the commencement of the core conversion from HEU to LEU fuel. A condition essentially needed for safety and environmental impact assessment to obtain the core conversion (removal) program license. In doing so, a source term estimation and radiological safety assessment were initially performed. ...

Combined Effect Of Rheological Model And Equivalent Diameter Definitions On Pressure Losses/Equvalent Circulating Density Estimation.

ABSTRACT Without accurate estimation of annular pressure losses it is possible to face serious problems that would yield to interruption in drilling operation and sometimes lead to the abandonment of the well. Therefore, exact estimation of annular pressure losses is vital in drilling and well completion operations to control formation pressure and optimize drilling and completion fluids hydraulic program. Many investigators have proposed different equivalent diameter concept to provide a si...

Diagnostic Plots For Analysis Of Water Production And Reservoir Performance (A Case Study)

ABSTRACT The research is aimed at the understanding of the various diagnostic plots for the analysis of water production that are available as well as the application of these methods in a case study. It also aimed at the establishment of a work flow for the evaluation of water production mechanisms. A workflow was developed that combines numerical simulation and diagnostic plots to analyze the water production performance in a reservoir. This workflow was validated using a case study. The m...

Deepwater Petroleum Exploration And Production In The Gulf Of Guinea: Comparative Analysis Of Petroleum Fiscal Systems Performance

ABSTRACT Petroleum Fiscal System (PFS) is a major determinant of investment decision in the exploration and production of oil and gas in any country. It basically describes the profitability relationship between the host government of the producing community and the International Oil Companies (IOCs). The comparative analysis of the performance of the fiscal regimes becomes imperative as it affects the interest of the investor and the production of oil and gas. During the formulation of any ...

Technical Assessment Of Mining Site And Barite Quality In Nigeria

ABSTRACT Barite is an exceptional non-metallic mineral composed of barium sulphate and it is used mainly by the oil and gas industry as drilling mud in deep drilling, where high pressure is encountered. The specific gravity of barite should range from 4.2 to 4.6 in order to be used as drilling mud. In Nigeria, barite deposits are found in veins and cavities hosted by varieties of rocks. In this work, barite deposits in various troughs of Nigeria have been sampled and analysed for the purpose...

Effect Of Gas-Oil-Ratio On Oil Production

ABSTRACT Maximum production from an oil well can be achieved through proper selection of tubing size. The selection of optimum tubing size must be evaluated when completing a well in any type of reservoir especially solution gas drive reservoir since there is likelihood of producing more gas as the reservoir pressure declines. The most widely used methods such as Tarner, Muskat and Tracy methods for predicting the performance of a solution gas drive reservoir were discussed and used to estim...


1741 - 1755 Of 3414 Results
@